Quote:
Originally Posted by GMP
FWIW, there is no real "midvalve" setup in the fork, its just a checkplate with a .3mm shim. Yes, start with fixing the rebound stack first and try it to gauge the diference. Next, go back in and replace the .3mm with the following over the spring:
22 x .1
22 x .1
19 x .1
15 x .1 (stack to adjust float)
Try a float of 1.4 - 1.5 for starters, and work down until it gets more harsh, then back up. This helps slow things down a bit.
|
Just installed the shims, and I hope to get the bike out for a ride to try it out tomorrow.
I went to the exact MV setup you list above, and need 0.3 mm of 15mm shims to get a float of 1.5mm. What do you think of this rebound stack
22 x 0.1
22 x 0.1
19 x 0.1
19 x 0.1
18 x 0.1
17 x 0.1
15 x 0.1
12 x 0.1
I'm concerned that I may have taken too big of a step here as I was running
22 x 0.1
19 x 0.1
17 x 0.1
15 x 0.1
12 x 0.1
12 x 0.1
Thoughts?