|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
GG specify piston/bore clearance 0.06mm where is this measured?
Is it minimum jug diameter (narrowest point) to quoted piston size (not sure if quoted piston size is the max diameter?) in effect meaning this would be a minimum clearance cold.
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Where is a piston measured 71.95 at top, middle or bottom? | stay_upright | Enduro Engine - 2 stroke | 1 | 07-25-2009 07:34 PM |
Measured Squish @ 1.83mm! | GG27 | Enduro Engine - 2 stroke | 9 | 06-11-2009 04:55 AM |
FYI, check BDC piston/lower port clearance. | socalscott | Enduro Engine - 2 stroke | 3 | 11-26-2008 01:43 PM |
"B" piston in an "A" bore? | Kokanee | Enduro Engine - 2 stroke | 6 | 09-04-2006 07:10 PM |