|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Wiring Hi/Lo Beam
OK, showing ignorance here but need someone to confirm what is probably obvious.
I added a 6" light bar to my XC a while back, with harness and relay. Now I am upgrading to the LED and want to add in the Low Beam. I purchased a new SPDT switch (two position) to replace the single-throw that I was using to run the light bar, thinking that I would just run a wire from the switch to the low beam. But that's not how it works, right? Do I have to run a second harness and relay back to the battery for the Low Beam (as well as the high beam)? Or is there a way to simplify? Thanks, Jeff
__________________
'18 GG XC 300 '05 GG DE 300 '01 GG txt 321 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wiring Help | savage sausage | Enduro Electrical & Wiring | 3 | 12-23-2016 05:33 PM |
headlight- high or low beam? | evanchochrek | Enduro Electrical & Wiring | 3 | 10-23-2014 07:07 PM |
2002 ec300 light wiring and speedo wiring help needed. | andy176 | Enduro Electrical & Wiring | 0 | 02-04-2014 07:38 AM |
Sand Creek Post and Beam | Clay | General Discussions & Announcements | 10 | 12-21-2012 08:10 PM |
wiring a fan | swazi_matt | Enduro Electrical & Wiring | 5 | 05-04-2011 12:50 PM |