|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Marzocchi 45mm Questions
OK finally started servicing the forks plus I was going to stiffen up the rebound stacks.
So Q1 - I bought replacement dust seals - oil has been weeping past the seals on both fork - should I be replacing the oil seals as well - I didn't realise the dust seals were not the oil seals but I think in the UK it is common only to replace the dust seals when the forks are leaking a bit... Q2 - Does the standard spring pre-load tube look like the picture in the manual? The reason I ask is mine looks a lot longer - maybe it has been replaced in the past...? Any measurements for what it should be? I'm guessing mine is about 2" long. Q3 - Are most people running 90mm oil height, I was using 140mm last time - this was tuned to resist bottoming so maybe I need to go with 90mm but run less preload (if mine is in fact more) and/or reduce stiffness in the compression stack.. Anything else I should be looking for/doing while I've got them apart. One final thing - I've made a Word document from the PDF manual cutting out all non-english bits and rubbish - the idea being I only need to print 21 pages not 118 would the admin be interested in putting this in the manuals section along with the original manual?
__________________
'05 Gas Gas 300 '97 Aprilia Pegaso 650 '99 KTM 200 '95 ish XR630 (died many times in Oz) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seal replacement on conventional 45mm Marzocchi? | renotsttam | Enduro Suspension | 6 | 06-14-2015 01:29 PM |
Marzocchi 45mm mid valve check plate | stay_upright | Enduro Suspension | 10 | 04-02-2010 12:37 AM |
Marzocchi 45mm Shiver manual | super_rat | Enduro Suspension | 1 | 01-01-2009 10:24 PM |
Marzocchi 45mm bushes | iancp5 | Enduro Suspension | 0 | 02-25-2008 02:49 AM |