|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Swingarm Bearings
Didn't want to wander off topic from the first issue. So I managed to easily remove all the bearings from the linkage using a hand press at work. I took the swingarm in and tried the same process. They seem to be a bit more of a challenge, I really wasn't sure of how much pressure was required to remove the bearings. I plan on making an arbor that will fit a bit closer to make sure that I'm appling pressure evenly. Does heat help out or do you need to use a hydraulic press to remove these bearings? Thanks Carl.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Swingarm and Linkage Bearings | blitz11 | Enduro Chassis & Body | 34 | 01-12-2015 03:41 PM |
Swingarm bolt | goose202 | Enduro Chassis & Body | 6 | 04-14-2009 08:01 AM |
Swingarm bearings | rupecopp | Enduro Chassis & Body | 0 | 06-16-2008 03:56 PM |
ec200 swingarm bearings | rupecopp | Enduro Engine - 2 stroke | 2 | 07-30-2007 12:54 PM |