|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#81
|
||||
|
||||
Quote:
The .10mm face shim makes sense, I may try that |
#82
|
||||
|
||||
Quote:
between the piston face and the first shim or face shim...I used a feeler gauge and guesstimated as close to 1.5mm as I could without any deflection of the shim. I trail only, logs, roots, rocks, all woods and jungle stuff...no mx. That's why I can get away with a softer valving setting. Did I mention I did go to stiffer springs front and rear, so that I can get the bike to ride higher in the stroke. |
#83
|
||||
|
||||
Your lucky i telephoned marzzochi today they could not help at all with the stock shim set up. They advised me to speak to GG uk.
I didnt bother cos GGuk would only tell me to speak to Marzzochi. ho hum
__________________
1998 EC250 07 Shivers 2T racing PV Spacer FMF Gnarly |
#84
|
||||
|
||||
Try calling Steve Plain, they do a lot of suspension for GG's in the UK.
www.steve-plain.co.uk
__________________
mint 2008 EC200. Earlier bikes: Husqvarna WR125 '12, Husaberg FE450 '10, Sherco 4.5i '05, EC300 '07, YZ450 '03, WR250F '01, WR400F '00. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
anybody know of a good setup for LTR kit on an 03 Ec250? | dank | Enduro Intake/Carburetion - 2 stroke | 5 | 02-27-2010 02:43 PM |
Marzocchi experts - help with 08' EC250. | nick790 | Enduro Suspension | 1 | 05-09-2009 02:41 PM |
05 EC250 Marzocchi stock shim arrangement ? | ferguscawley | Enduro Suspension | 10 | 01-10-2008 07:49 AM |
450 Timing setup | Motarded1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 11-04-2007 03:24 PM |
Need help with EC 300 setup | Texas Gasser | Enduro Suspension | 4 | 05-24-2007 06:21 AM |