|
GasGas Member Polls Find out what everyone thinks about it! |
View Poll Results: Do u have and like your 2018 Gasser GP300? | |||
Yes, yes | 15 | 44.12% | |
Yes, no | 0 | 0% | |
Yes, kind of | 0 | 0% | |
No, wish i did | 19 | 55.88% | |
Voters: 34. You may not vote on this poll |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Quote:
So far I'm enjoying the great handling of my GP300 and just swapped one fork spring only to a 0.46 kg/mm spring. I had an old 5.5kg/mm Sachs shock spring from my departed EC450 which also happened to fit in the KYB shock. Keg, what are your current carby settings? Still trying to sort the dreaded 1/4 throttle splutter + spooge & currently running 35PJ NECG #2, 172MJ with AS 0.75 turns out. Getting a bit more snap off the bottom now, then splutter followed by ballistic mid range. I'm currently waiting for NEDH needle to show up at my local Suzuki dealer so I can try 38PJ NEDH#2, 172MJ.
__________________
GG GP300 18 KTM 350EXC 17 GG EC 450, GG EC 250 08, KTM 525 EXC 06, KTM 400 EXC 01, XR400 97, VTR1000 98, VFR750 95, Husaberg FE400 96, RMX250 91, Maico 490 84, IT250J 81, RM250C2 79, Bultaco Alpina 250 77 - All sold |
#12
|
|||
|
|||
Hi Ecrider,don't forget Keggo's running a 250.
I'm having a ball with my GP300 with n3cj #2,175 main,42 pilot,air screw 1 turn out.power valve 2 1/4 turns out. altitude 200m-1150m. GRO offroad 1 @50;1 I don't give a toss about the spooge hype,but get bugger all anyway.....
__________________
2011 TXT300R 2018 EC300GP |
#13
|
|||
|
|||
Quote:
|
#14
|
|||
|
|||
Thanks guys, I thought Keg had a GP300.
I tried 45PJ N3CH #2 178MJ (close to N3CJ) & found 2 clips down to be too lean at 1/2 throttle, but spluttering low. I might retry as 42PJ N3CH#3 175M I'm using Penrite synthetic 50:1 at 100m. Float level set at 8.5mm
__________________
GG GP300 18 KTM 350EXC 17 GG EC 450, GG EC 250 08, KTM 525 EXC 06, KTM 400 EXC 01, XR400 97, VTR1000 98, VFR750 95, Husaberg FE400 96, RMX250 91, Maico 490 84, IT250J 81, RM250C2 79, Bultaco Alpina 250 77 - All sold |
#15
|
|||
|
|||
Gibnut, I'm running 40 pilot, 172 main, NEDW #2, AS 2 turns out ('18 XC250). 2000-5000 ft elevation. 70-90 degrees F. I still feel like the bike is a little rich and am still getting a great deal of spooge. I am wondering if the cable actuated choke is contributing to this? I will swap with plunger choke and re-evaluate.
Last edited by Jacob 'Berg; 05-03-2018 at 12:52 PM. |
#16
|
|||
|
|||
Quote:
Sorry for the thread hijack.. |
#17
|
|||
|
|||
Quote:
|
#18
|
|||
|
|||
Indeed, Cactus Flat. Here in Australia, we have a 2-t tuning house in Melbourne called TSP. My head will probably go to them for attention when I do my first top end - unless the 250GP head is shown to be a marked improvement over stock.
|
#19
|
|||
|
|||
After my mate bought one 4 weeks ago and I could test ride it I immediately ordered one and will get it tomorrow.
The reason why I bought it and why I'll sell my KTM300/17 is that the suspension and brakes are the best I ever tried and I tried a lot. I have a completely revalved and tuned suspension on the Kato but the KYB stuff is even better right out of the box. And I get the brake I always wanted. Although I use the same Nissin master on the KTM it does not even come close to the Gasser's stopping power. Its amazing. Regards from Europe Doc |
#20
|
|||
|
|||
Quote:
I will go a 180main as it feels a little flat up top in sand. I get some spooge when lugging the bike a gear higher in slippery or rough terrain. But that is the whole point of lugging. It makes lower velocity through the carb and runs very rich so it is smooth torquey power delivery that won?t break traction, but you get unburnt fuel out the back. I don?t try to jet that as it will be lean in the fast stuff and less torquey in the technical terrain.
__________________
EC300 2019 (11 Gassers owned, many more to go) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 | Stoby | General Discussions & Announcements | 23 | 04-18-2018 04:07 PM |
New 2018 300 | markwoodlief | Enduro Product Reviews | 31 | 04-18-2018 04:06 PM |
Ec200 2018?? | ylisuutari | General Discussions & Announcements | 20 | 02-07-2018 05:02 AM |
2018 250's | nhgas | General Discussions & Announcements | 1 | 09-22-2017 04:17 AM |
2018 models | imsimon | General Discussions & Announcements | 16 | 02-28-2017 09:39 PM |