|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
02-28-2018, 01:10 PM
|
|||
|
|||
2007 ec250 cylinder markings
Just curious if this is factory markings on the back of my cylinder or has someone been playing with this one? I haven't pulled the head to measure the bore as of yet.
If it's hard to see there is 285 stamped rear center of the cylinder twice (one over the other). There is also other stampings on the right side that I would guess are factory, but these looked different to me. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cylinder markings on wall any ideas?? | nambo-trev | Enduro Engine - 2 stroke | 16 | 05-09-2013 11:27 PM |
| Keihin ASII markings? | byost | Enduro Intake/Carburetion - 2 stroke | 2 | 05-02-2012 07:23 PM |
| needle with no markings... | jhendr3702 | Enduro Intake/Carburetion - 2 stroke | 2 | 03-17-2009 08:26 PM |
Threaded Mode