|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Flexx bars bolt hitting brake line/fitting
For those of you running fasst flexx bars. Did any of you have a problem with the bushing bolts hitting the brake line banjo bolt fitting? If so what did you do? I don't want to move my Lever to a different position because it's comfortable for me where it's at. Thanks!
__________________
2013 GasGas XC300E 2005 YZ290 1973 Honda CB175 1997 KX60 1983 Yami Tri-Zinger 1984 Suzuki Alt 50 1969 Trail 90 1971 Trail 90 1972 Trail 90 |
#2
|
||||
|
||||
You have to grind upper brake hose locating pin off and rotate the hose upwards.
You may have to bend the hose out towards the front of the master cylinder. |
#3
|
|||
|
|||
That makes sense. I've bent the fitting a little but I'll hit the housing with a grinder next.
Thanks
__________________
2013 GasGas XC300E 2005 YZ290 1973 Honda CB175 1997 KX60 1983 Yami Tri-Zinger 1984 Suzuki Alt 50 1969 Trail 90 1971 Trail 90 1972 Trail 90 |
#4
|
||||
|
||||
You can order a pre-bent brake line from Galfer. I did this on my '11 bike.
You will need the "E" model. You may not have to grind the pins off with the 90 hose. http://www.galferusa.com/wp-content/...ne%20Sheet.pdf |
#5
|
|||
|
|||
Thanks! I'll try moving the existing line first I think.
I've never seen the Galfer order form. That's awsome!
__________________
2013 GasGas XC300E 2005 YZ290 1973 Honda CB175 1997 KX60 1983 Yami Tri-Zinger 1984 Suzuki Alt 50 1969 Trail 90 1971 Trail 90 1972 Trail 90 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
flexx bars | cogassr | Parts | 3 | 03-05-2015 11:11 AM |
Flexx bars | baker | Parts | 0 | 02-17-2014 05:01 PM |
Flexx bars, any good? | Pepperami | Enduro Chassis & Body | 7 | 12-08-2012 05:35 AM |
Flexx Bars | Clay | General Discussions & Announcements | 65 | 02-27-2012 05:38 PM |