|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Before you play too much try and bring the idle down nice and low with the idle screw, and then adjust the air screw. I'd suggest 1.5 turns from fully seated, but you may come out further. If it idles up when you open the air screw you can bring the idle back down again with the idle screw. When its on the money it'll tick over like a sewing machine, and the air screw will be quite effective where opening it up causes a lean condition and going rich makes it want to flame out a bit.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jetting ? | rootsnrocks | Enduro Intake/Carburetion - 2 stroke | 38 | 03-12-2013 02:22 AM |
jetting help | BryanMcc | Enduro Engine - 2 stroke | 8 | 07-26-2012 11:45 PM |
jetting help for 05 300 please... | mackmack | Enduro Intake/Carburetion - 2 stroke | 5 | 09-03-2007 05:10 PM |
06 300 jetting | fury1 | Enduro Intake/Carburetion - 2 stroke | 1 | 07-31-2007 06:37 AM |
02 ec 250 jetting help | crem55 | Enduro Intake/Carburetion - 2 stroke | 9 | 07-12-2007 01:44 PM |