09 EC300R Fork Compression re-valving

[Keg]

Hi all,

I feel the high speed valving could do with a bit of a tweak. I am 110kgs (242lbs) and have 0.46kg fork springs in it!

Here is what is in it:

26D x .15 (5)
24 x .2
12 x .15
22 x .2
20 x .2
18 x .15
61 x .15
12 x .15
10 x .3

Firstly where do I get 7mm id shims from? I have been die grinding KTM shims so far.

My new stack is:

26D x .15 (3)
24 x .1 (3)
12 x .15
22 x .2
20 x .1
18 x .15
61 x .15
12 x .15
10 x .3

Any suggestions???

[JRDoz]

Originally Posted by Keg

Hi all,

I feel the high speed valving could do with a bit of a tweak. I am 110kgs (242lbs) and have 0.46kg fork springs in it!

Here is what is in it:

26D x .15 (5)
24 x .2
12 x .15
22 x .2
20 x .2
18 x .15
61 x .15
12 x .15
10 x .3

Firstly where do I get 7mm id shims from? I have been die grinding KTM shims so far.

My new stack is:

26D x .15 (3)
24 x .1 (3)
12 x .15
22 x .2
20 x .1
18 x .15
61 x .15
12 x .15
10 x .3

Any suggestions???

Lose a few kilos, worked for me

[stay_upright]

Suggestions about the shim stack or where to get 7mm shims from? I would have thought Go Fasters would have the shims you need - though didn't look to see if you are in the US.

[Keg]

I did some testing last night and I have actually gone the wrong way I think. I need to increase the compression.

I might chuck out the delta shims, put the 20 x .2 back in and either change the cross over shim to a smaller one or make it a single stage stack instead.

I'm in Melbourne, Australia and have got some shims out of Sydney, but I will get onto go faster about them. Anyone know a contact for paioli on Europe as they are the same shim too.

[Keg]

Bump! Anyone?

[stay_upright]

No sorry .