|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Turn signals
I purchased LED turn signals but need to know how to wire them into my 03 GGec300?????? Any and all help would be appreciated!!!!
Thanks Lee, |
#2
|
||||
|
||||
Quote:
http://www.gasgasrider.org/forum/showthread.php?t=7900 And the how to go DC thread. http://www.gasgasrider.org/forum/showthread.php?t=1859 Some info there. As far as I understand you need DC power to properly run LEDs. I did the floating ground conversion and run DC with a small sealed lead acid battery on my '02 XC/EC300. I suppose you could wire a dedicated / isolated, constant loss DC system to just run the turn signals. Use a small 4-5Ah battery and charge it at home before you use the bike. Might be more trouble than doing it right. To make my conversion way easier I bought a used Full EC wiring harness from a forum member from Canada to replace the XC harness from my bike. Happy hunting and good luck. Jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Turn Signals | Wicitup | General Discussions & Announcements | 15 | 10-28-2014 04:12 PM |
Front end wont turn | Malcolm | Enduro Suspension | 4 | 05-23-2011 01:56 PM |
Its my turn to have a Ear to Ear Grin. | REVERUP | General Discussions & Announcements | 26 | 12-22-2010 05:33 PM |
1/4 turn throttle ? | enduro1 | General Discussions & Announcements | 0 | 08-19-2010 01:55 PM |