|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#10
|
|||
|
|||
Keep in mind a meter draws very little current to operate. You might have just enough connection to work the meter, but not enough to light a bulb. This usually means a poor connection or multiple poor connections. It is not unheard of to have a break inside a wire that otherwise looks good.
Does the stator look good or is it a rusty mess? Floating the ground does make it a lot simpler as it takes the engine/frame connection away. Did you measure the resistance on the windings? Bad solder joint on the stator?
__________________
2011 EC250E |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2006 ec300 wiring/lights | clyde34 | United Kingdom | 2 | 09-07-2023 08:51 PM |
GAS GAS SM 250 2002 - Lights Wiring Issue Help | Yammotfra | Enduro Electrical & Wiring | 2 | 12-30-2020 07:52 AM |
Wiring issue (lights) | Lukeeccles | Enduro Electrical & Wiring | 6 | 10-09-2018 11:18 AM |
2002 ec300 light wiring and speedo wiring help needed. | andy176 | Enduro Electrical & Wiring | 0 | 02-04-2014 07:38 AM |